Brake Pad Warning Light Mot Failure

27 Apr, 2018 Post a Comment

Brake pad light won t fail we won t even pay any attention to it however if the pads are worn excessively ie touching steel to steel it will fail abs light at the minute is the only warning light to fail it has been suggested in 2012 srs lights will become part of the test but this is silly in my eyes as there is no way to test the srs system without crashing the car where as abs can be tested via a test drive. Some vehicles have a warning light on the dashboard to show when brake pads become worn.

Pin On Www Autofind Co Za

If the warning light is lit the tester will fail it unless it can be seen that there is another reason for it being lit.

Brake pad warning light mot failure. Will having the brake pad warning light on the dash fail an mot. Sometimes this lamp is shared with other components such as to show that the handbrake is applied. The pads aren t that low and its just one of the wires of the pads have broken so has broken the circuit and tripped the sensor.

What to do when the brake pad wear indicator warning light is on if the light comes on you should bring the vehicle to a certified technician to have the brakes replaced. Brake pad warning lights. Many modern cars have sensors and that monitor brake pads and a warning light that will tell you when it is time for them to be replaced.

However any issues with the sensors themselves will cause the light to turn on. An astonishing 1 422 of the most ridiculous fails. It will fail if the red brake warning light is on.

The most common mot failures are tyre tread depth falling below the 1 6mm limit work out brake pads and a lack of windscreen washer fluid. Before you mark a fault check it isn t lit for any other reason. Some vehicles have a warning light on the dashboard to indicate that the brake pads are becoming excessively worn.

It could be as a certain special someone said the brake fluid needing topped up could be a sticky handbrake switch could be a brake pad sensor could be an abs sensor or sensor ring. When the seals in the master cylinder fail the disproportion in brake pressure will turn the brake warning light on which means the brake master cylinder will need to be replaced. It may also light up for other reasons for example when the handbrake is applied.

This condition is usually followed by a low or fading brake pedal. Deteriorated or faded number plate the law states that a number plate must be visible to someone standing 20 metres away from a vehicle. More than likely the light will shut off with the new pads installed.

Automatic Electric Gates For Your Home Infographic With Images